ARKMICRO USB-UART CABLE DRIVER

Going of another thread here I suspect that the wires in the cable are as follows: I only see the same COM1 port that has been there before. Mon Jun 13, 0: I never see any amber light flashing and no output on the console terminal. Community Projects View Projects. How else can you tell which wire runs to which pin if you dont crack open the end?

Uploader: Brajora
Date Added: 2 April 2005
File Size: 45.48 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 68079
Price: Free* [*Free Regsitration Required]

USB to UART driver for Windows 10 (Cypress) | Zedboard

If there is no signal, then you may be on the RX line. Skip to main content. So when you touch the red multimeter to 1 wire, and the black multimeter to one of the USB jack ends, you should see 0 Ohm or hear a Beep That means you have the same wire. Tried an old laptop with XP. Between each attempt I restarted windows after uninstalling previous driver and restarted again after installing new driver.

That leaves your other line as RX.

Installed the driver and utility from the Serial Recovery Wiki. Wrong unfortunately, the multimeter does NOT provide power.

Zedboard forums is currently read-only while it under goes maintenance. Mon Jun 13, 0: Cannot see new device, COM port in device manager. I measured all the wires.

  HP DESIGNJET Z5200 DRIVER DOWNLOAD

If you try doing it from the computer end of the cable, how are you going to tell which signal aarkmicro which and what the values are supposed to be? Pick one of the wires and attach the black multimeter lead to it. You still have to determine what wire is what.

I tried the USB device viewer but neither it or windows seems to think there is a connection. Please try looking at these posts http: To test the cable, you have to plug it into the USB port of the computer.

Usb-uatr Jun 13, And no, there is no SET color coding – manufacturers choose whatever they want. You can google how to use a multimeter.

man uark (4): Arkmicro Technologies ARK based USB serial adapter

I only see the same COM1 port that has been there before. If I try to update the drivers for such COM1 port and select Win7 drivers from Cypress installed folders then it does change the type arkmiicro the port to USB serial port but still does not work.

In my uneducated guess, I believe this means the colors listed above are correct. So just plugging it in, without the other end hooked up to anything, cabe means its a good cable. I know its been said you can find the ground by measuring the ohms with a multimeter set to OHM.

  ICH5 SOUND DRIVER DOWNLOAD

Arkmicro Technologies Inc. ARK3116 Serial

Display posts from previous: Log in Profile View unanswered posts Log in Username: All these USB to serial cables have a chip inside them. I have Win 7 x They are very clsoe together on the Zedboard, jeje. Black is the only wire to give a reading, and when i touch the red wire, and hold it to the positive lead my Win 7 PC actually recognized the cable.

Hooked up the red cable to match up to the 3V3 pad on the router for power and twisted the blue and white just to test out the prolific drivers from the wiki. Hooked up the power and ground to the router. Hi Carlitos, Unfortunatly I haven’t encountered your issue in the past. Going of another thread here I suspect that the wires in the cable are as follows: I also tried on Windows 7.